[Elecraft] HRD and K3

[Joe Subich, W4TV]

 > Any other ideas??

Are you using MODE=DATA and data sub-mode=DATA_A?

 > MIC SEL was set to Line In I changed it to FP
 >
 > MIC+LIN was set to NA and I set it ON and the MIC level is set to 60.

Set MIC+LIN back to OFF, set Mic SEL back to Line In, place DM780 in
PSK31 transmit and adjust the Mic Gain (actually Line Gain in DATA_A)
for four bars of ALC with the fifth just flickering then adjust PWR Out
for no more than 50W.

73,

    ... Joe, W4TV


On 8/8/2015 8:43 AM, Larry Snyder wrote:
> I have my K3 connected to the PC and the K3 software works fine.
>
>
>
> I have 2 audio cables between Line IN and Line Out of the K3 to the Mic and
> Speakers on the PC.
>
>
>
> With HRD - I see the QSOs on the screen and of course the waterfall display
> at the bottom with an Audio level of 10%.    When I attempt to call CQ -
>
>
>
> The K3 goes into transmit but there is no power coming out of the radio.
>
>
>
> MIC SEL was set to Line In I changed it to FP
>
> MIC+LIN was set to NA and I set it ON and the MIC level is set to 60.
>
>
>
> Still no difference.
>
>
>
> Any other ideas??
>
>
>
> Sincerely
>
>
>
> Larry
>
>
>
> --
>
> Larry Snyder, RN.ORG, SA  - HK2LS
>
> "Each and Every Day Thousands of Nurses Depend on www.RN.org
> <http://www.rn.org/>  for their Nursing CEUs!"
>