[Elecraft] K144XV

[Mark]

Elecraft got right back to me on this - error in the manual.

>From Elecraft:

The KXV144 power cord plugs in to P95 (near the batt on the RF board)  the 
pin 1 end
Thanks for pointing the error out in the K3S Manual.


73

Mark, ab7mp



-----Original Message----- 
From: Mark
Sent: Friday, August 07, 2015 10:40 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K144XV

Has anybody run into this?

Building my K3S and I'm ready to install the K144XV which needs a 1-pin
connector on the RF board.  The two options in the instructions don't seem
to match my board and the errata sheet doesn't address it.  I've sent email
to tech support, but really need to wrap this project up before the wife
gets home tonight and finds her dining table looking like a work bench!!

I've been looking through the radio for a 1-pin unused connector
pre-installed - no joy.

The instructions indicate two possible locations near U12 and C198.  No
holes in that location on my board.

73

Mark, ab7mp (S# 10186)

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to ab7mp at arrl.net