[Elecraft] K144XV

[Mark]

Has anybody run into this?

Building my K3S and I'm ready to install the K144XV which needs a 1-pin 
connector on the RF board.  The two options in the instructions don't seem 
to match my board and the errata sheet doesn't address it.  I've sent email 
to tech support, but really need to wrap this project up before the wife 
gets home tonight and finds her dining table looking like a work bench!!

I've been looking through the radio for a 1-pin unused connector 
pre-installed - no joy.

The instructions indicate two possible locations near U12 and C198.  No 
holes in that location on my board.

73

Mark, ab7mp (S# 10186)