[Elecraft] TXMonitor

[Alan]

The P3 TX monitor automatically detects what type of sensor is 
installed.  The sensor includes a resistor connected to one of the 
connector pins.  The P3 reads the resistor value to figure out which 
sensor (200W HF, 2 kW HF or VHF) is installed.

Alan N1AL


On 08/05/2015 07:56 AM, hsherriff wrote:
>
>
> Received mine yesterday. Was thinking of making a switching box to switch between sensors. Looking at the manual, looks like you need to tell the P3 the span of the current sensor. Could do this via a arduino but the programmer's manual hasn't been updated for the TXmonitor. Anyone know the commands associated with the monitor functions?
> Harlan NC3C
>
>
> Sent from my Verizon Wireless 4G LTE smartphone
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n1al at sonic.net
>
>