[Elecraft] KXV3B Installation

[Don Wilhelm]

Removing the entire left side panel makes installation of the KXV3B 
module even easier.
As an additional hint, bend the pins of the KXV3B connector slightly 
toward the front - about 1/16 inch at the tips of the pins is enough.  
That will allow you to more easily install the new option.

73,
Don W3FPR

On 8/2/2015 8:08 PM, Jobst Vandrey wrote:
> As others have noted, removing the two screws on the rear of the left panel
> makes the installation easier.  Especially in order to attach the lock
> washer and nut on the bottom corner of the KXV3B module with my XXL
> fingers..
>