[Elecraft] Hi Cur and Hi SWR using KX3 2 meter Module

[Jack F6AJW]

???? No text except title?

I have the same issue on my KX3-2m: "Hi-Current" blinking even on dummy 
load but 3 W output still available . Having a loose SMA connector , I 
had to open KX3 and extract 2m card in order to tighten SMA nut (very 
annoying!) . I found it was convenient to use a short piece of coax 
cable with SMA male connector and N female (or what you want) at the 
other end in order to avoid stress on SMA female on KX3 .

KX3-2M is very sensitive but a lot of birdies presents so this is not 
very compatible with weak signals reception, even using transverters in 
front adding noise masking the weakest ones compared to my IC-7400 and 
other transceivers . My DB6NT microwave transverters are well driven 
into TX using + TX available on SMA inner conductor; very good point! 
Another issue I have  is a sort of "microphone effect" in RX ; not sure 
this is the right words ?

Any help?

73's.

Jacques F6AJW/IN93EK



Le 01/08/2015 15:18, John Sager via Elecraft a écrit :
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to jack.f6ajw at gmail.com
>
> ---
> L'absence de virus dans ce courrier électronique a été vérifiée par le logiciel antivirus Avast.
> https://www.avast.com/antivirus
>


---
L'absence de virus dans ce courrier électronique a été vérifiée par le logiciel antivirus Avast.
https://www.avast.com/antivirus