[Elecraft] New synth

[Rick Bates]

Fine tipped hemostats, with ribbed teeth. 

Loosen part way, clamp the washer, continue removal of bolt.  Repeat as needed until old card(s) removed. 

73,
Rick wa6nhc

Tiny iPhone 5 keypad, typos are inevitable

> On Apr 13, 2015, at 8:05 PM, Don Wilhelm <w3fpr at embarqmail.com> wrote:
> 
> 
> There have been several posts about the concern for dropping a lockwasher when switching synth boards.
> You might want to try my technique:
> Unscrew the 1/4 inch screws 2/3 to 3/4 of the way.  Then tilt the old synth board toward the rear.
> Then push the lockwashers as close to the synth board as possible.
> Unscrew the screws completely while holding the top of the synth board toward the rear.
> Then lift the synth board upward and out of the K3.
> No dropped lockwashers.
> 
> 73,
> Don W3FPR
> 
>> On 4/13/2015 10:38 PM, David Cole wrote:
>> First thing I did was to drop a washer...  The washer was magnetic, so I
>> got it with a mag stick...  Be VERY CAREFUL removing the boards!
>> Remember the washer...
>> 
>> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to happymoosephoto at gmail.com