[Elecraft] KX3 6 meter repeater memory channel programming

[Matt Zilmer]

Hi John,

I had a similar issue with an odd High-VHF split.  For odd splits, we
have to use the KX3 itself.  The utility allows only standard tx/rx
splits to be entered..

1. Enter the transmit freq into VFO A;
2. Tap the A/B switch;
3. Enter the receive freq into VFO A;
4. Tap the A/B switch;
5. Hold SPLIT to allow different tx and rx frequencies.

When this is done properly, VFO B will show your tx frequency, and VFO
shows your rx frequency.

If you'd like to you can memorize the channel.  I would.  Set the PL
frequency first if the repeater needs it.

73!

matt
W6NIA

On Fri, 3 Apr 2015 01:12:11 +0000 (UTC), you wrote:

>All, I am missing something or having a senior moment.  I have tried the memory editor to put in a -1.7 mhz offset 6 meter repeater....no luck.  Only get -1 mhz offset.
>Must be missing something or assuming something.  Anyone been here before and know the best way to store this in a KX3 memory channel?
>Thanks, John N0EVH
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
>Message delivered to mzilmer at roadrunner.com
Matt Zilmer, W6NIA
--
"Always store beer in a dark place."  -R. Heinlein