[Elecraft] K2 Mikes

[Dominic Baines]

Dummy question...

I've got a K2 serial c5500 added the KSB2 module I have a Yaseu mic 
MH-31 (No additional pre-amp fitted) will to do the SSB test and 
alignment with it... however the K2 is going to someone who uses an ICOM 
mike, type unknown. (Yes will need to know if need to add pin 2 for a 
pre-amp...checking)

Anything that might be very different between them from those in the 
know that would make alignment with one irrelevant for the other?
I'm pretty sure I will have to wire differently on the unit for the 
inital mike and the final one (bit of a pain ho hum), apart from the 
jumpers and details listed P17/18 in the KSB2 manual. 
http://www.elecraft.com/manual/ksb2%20manual%20rev%20G.pdf

Or anyone suggest suitable tests just to make sure it is all working 
fine? I could think a PTT and/or an up/down break out board and switches 
might be worth doing?

72/73
Dom
M1KTA