[Elecraft] K2 Build #7552

[Don Wilhelm]

Kevin,

That is "telling" that you have not truly flush trimmed the lead on the 
encoder board and the area of the control board where it makes potential 
contact.   There is not a lot of space for error there.

Flush trimmed means really flush with the board thickness.  Solder that 
protrudes from the board surface is too much.

you may do well by putting an insulating substance such as a layer of 
electrical tape over the encoder board after flush trimming it.

73,
Don W3FPR


On 9/28/2014 10:14 PM, Kevin Schache wrote:
>
> Many thanks to Don and others who responded.
> The problem has been fixed, I found a suspect dry joint on the PTT/ATT 
> switch.
> I also checked the new encoder which appeared ok but I did insert a 
> very thin piece of insulation between the new encoder and the control 
> board to make sure.
>
> All tests now appear ok UNTIL I re-insert and tighten the two holding 
> screws in the Control Board. When these are tightened, the control 
> board is pulled about 1/8th inch toward front panel, probably 
> stressing both boards, causing the display to be erratic (ELICRAFT 
> instead of ELECRAFT  for example), and erratic other test results. 
> Stressing the boards may be causing movement in sockets where they are 
> used.
>
> Does it matter if I leave those two screws out?
> Another option would be to put in longer screws and not tighten them 
> so much, or perhaps a better suggestion maybe to increase the spacer 
> length marginally, so that there is no stressing.
>