[Elecraft] (K3) Filter Set-up

[Chuck Tifft via Elecraft]

I also had a solder problem with one of the filter slot steering diodes 
on one of my K3's. It was only soldered on one end.
Chuck
W6RD
On 9/27/2014 7:52 AM, Bruce Beford wrote:
> In addition to the other suggestions you have received (assuming still no
> signal through the filter), you may want to try the filter in another slot.
> Early on, I had the same problem after installing a 250 Hz filter. the
> problem ended up being a coupling cap on the circuit board with no solder on
> one end. I was able to find it, and touch it up myself. Mine was a fairly
> early unit (s/n 559).
>
>   
>
> GL,
>
> Bruce
>
> N1RX
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to chuckw6rd at yahoo.com
>