[Elecraft] KX3 2m module and problems

[Jim Klitzing]

Elecraft seems to have done a nice job on the transverter module for the 
KX3, just installed/tested one here. Pretty satisfied, but I'm wondering 
if anyone else  notices the strange frequency hopping in cw-in-ssb mode 
on 2m? Tone tends to warble a bit (hops frequency about 10 Hz). Doesn't 
seem to be there quite as bad in regular cw mode, but still there. Just 
detectable on 6m, and not apparent 28MHz and below, so this may be 
related to the stability limitations discussed before. That said, I'm 
hoping there will be a firmware upgrade to address this, as it make CW 
almost unusable on 2m...

Thanks, Jim