[Elecraft] Running Wide Split with FLDigi

[Wes (N7WS)]

I don't use FlDigi, but do use a variant of WinPSK. Set up a regular split using 
the "B" VFO by double tapping A->B to copy everything to B. Turn on "Split" and 
dial in the desired offset using the "B" VFO. If you need to check your TX freq, 
hold the "REV" key.


On 9/13/2014 7:02 PM, Ron Schwartz wrote:
> This may be a simple question, but how does FLDigi run wide (>2.5Khz) split with the K3?.  The waterfall does not allow the transmit frequency to be locked further than the sound card bandwidth from the receive frequency.  FYI, I do not have the K3 sub-receiver installed.  I presume some variation of the RIT/XIT controls, the VFO B control, and/or FLRig needs to be used, rather than using the transmit ‘Lk’ on the waterfall.
>
> Thanks, Ron
> K2RAS
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wes at triconet.org
>