[Elecraft] [KX3] Key Clicks

[Joel Black]

John,

Thanks for the tip.

I have a hard time filtering the F.O.D. on the KX3 Yahoo group. I'll go 
back and look there too.

I have set the DLY and finally got it where I can tolerate the key 
clicks, but the DLY is set to about 0.20 - basically, it only clicks at 
the end of transmit.

I *did* notice that even with my MON turned to 0 I still hear key clicks 
in my headphones (I have been wearing headphones the entire time I've 
been testing). I hear them as the rig stops transmitting.

Joel - W4JBB

On 9/13/14, 6:12 AM, John Oppenheimer wrote:
> Good morning Joel,
>
> Using 2.19. Same VFO B click with DLY = 0.00 and a little B side only
> tone ring at the end of the transmission. Increasing DLY to 0.06
> eliminates the clicks. My hunch is the same DSP pipe delay I mentioned
> in yesterday's Yahoo KX3 list QSK email.
>
> Not sure what the VFO B offset dependent frequency ring at the end of
> the transmission is.
>
> John KN5L
>
> On 09/13/2014 05:42 AM, Joel Black wrote:
>> With my KX3 terminated into a dummy load, split and dual watch active,
>> VFO B 1 - 5.3 kHz up or down from VFO A, filter set to 450 Hz and
>> centered, I am getting key clicks on VFO B. NB and NR are off.
>> Does anyone else notice this or is this an issue with my rig? If it's
>> me, what on *Earth* have I done to cause this?