[Elecraft] rather good service fer sure

riese-k3djc at juno.com riese-k3djc at juno.com
Fri Oct 31 20:22:33 EDT 2014



I had a bit of a problem installing the 144 board in the KX3 I built
actually the nut on the FET dropped off ,, I installed and removed the
unit
several times making sure the routing of the cables
I checked with Elecraft on the OK to use a drop of epoxy on the nut
and they suggested I send the KX3 back and allow them to do a full
install 
and set up

wild

that was an offer I couldnt refuse
the install of the trransverter was 
going well with no problems and I sure can
recommend the upgrade,,, it fits nice and the small coax connectors
popped
right into place
does anyone think any other manufacturer of ham gear would act in this
manor

anyone interested in a DEM 144 verter and a kenwood 850

Oh  it will be interesting to see how well the thing works as I am 200 Ft
from some very dirty 150 Mhz pagers,,, does effect the FM portion of 2
meters
but pretty clean at 144.2

Bob K3DJC



More information about the Elecraft mailing list