[Elecraft] RS232 interface

[G4GNX]

Sounds like a good idea for a tower/desktop PC but unfortunately I want to 
use a small notebook, which I use for logging and if/when I get the 
interface working, I can use it to connect to the K3 and my rotator 
controller.

I may consider it for one of my towers. Thanks for the suggestion.

73,

Alan. G4GNX

-----Original Message----- 
From: W2BLC
Sent: Saturday, October 25, 2014 2:17 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] RS232 interface

Perhaps the best bet is to install real serial ports - I have two. One
for the K3 and the other for my TS480. As I recall, I paid about $20 for
the board - a long time ago. It has been in several computers. To me,
the place for the adapter is inside the K3 - that way everyone gets the
same thing to work with and Elecraft will assure it works properly from
git go. No more screwing around with real/counterfeit/bogus products and
drivers - just a single source that works for sure.

Bill W2BLC K-Line