[Elecraft] K3/MMTTY/Signalink Problem

[Wes (N7WS)]

I didn't read the op so I'll add on here.

Make sure that the transmit mark frequency is the same as the receive 
frequency.  I've been bitten by this several times.  I like to use lower tones 
(915) because I listen to the incoming signal and the high tone drives me nuts.  
MMTTY defaults to 2125. If you use profiles then it's best to edit the .ini file 
directly and set these.

Wes  N7WS

On 10/13/2014 4:08 PM, Tom Blahovici wrote:
> Hi Paul,
> Although I do not use MMTTY ,  the fact that you have the lights and TX on the k3 working suggests that the ptt function (or VOX) is correct.
> The fact that all of the other software is working suggests that something related to the sound card settings in MMTTY is incorrect. Perhaps it has its own level controls or you have the wrong i/o settings.
> Can you receive correctly? Have you set the input on the k3 to the line in?
> Hope this helps.
> 73's Tom
> va2fsq.com
>
> On Oct 13, 2014 2:50 PM, paul ecker via Elecraft <elecraft at mailman.qth.net> wrote:
>> I am having problems getting MMTTY to transmitproperly using K3 with a Signalink USB interface.
>>
>> Currently, when I go to TX in MMTTY, I get red TXlight on Signalink, a red TX light on K3, I hear diddles coming out of theSignalink rear monitor jack, and  I seemovement on Vu meter in Windows sound playback tab. BUT I get no RF out on K3 RFmeter, no movement on K3 ALC meter and I am not hearing any diddles.
>>
>> - PC is Win 7 64 bit, i5 3.5ghz processor, 16gbof ram
>>
>> - My K3, Signalink, PC setup is working finewith DM780 PSK31, JT65HF, WSPR and WSJT-X.
>>
>> Would appreciate talking to someone who hasMMTTY running successfully  using K3 witha Signalink USB  to share setup information.
>>
>>   
>> Tnx & 73
>>
>> Paul
>>