[Elecraft] K3 KSYN3 Problems

[Don Wilhelm]

Mike,

It sounds like you have done everything recommended in the 
Troubleshooting part of the manual to isolate the problem.
Next step is to email customer support K3support at elecraft.com to see if 
they can offer any additional information.  They can give you 
information on the meaning of the extended error codes.

73,
Don W3FPR

On 10/12/2014 2:12 AM, Michael Eberle wrote:
>
> When the sub receiver is activated on any band 20 - 10 Meters, I 
> started getting ERR PL2 messages.  I opened the radio up and checked 
> all the cables and did not see anything obviously wrong. When I tried 
> the synthesizer calibration, I get error messages ERR PL2 E00130 and 
> ERR VC4 00039.  I pulled the KSYN3 boards and swapped them and the 
> problem followed it to the main receiver and the sub is fine.  Is 
> there anything that can be done short of ordering a new KSYN3 module?
>
> Thanks,
> Mike - KI0HA