[Elecraft] K2 and installing KSB2 & 160m

[Don Wilhelm]

An added note - the jumpers that Matt is referring to are supplied with 
the MH2 and the Elecraft Proset K2 microphones - they are NOT supplied 
with the KSB2 kit.
You can use the 2 pin female 'computer' jumpers for mic configuration 
header connections that connect straight across the header.

Examples:
-- for the Elecraft microphones, connect all pins straight across and 
solder the 5.6k resistor between pins 1 and 6 on the back of the 
microphone jack.
-- for Kenwood dynamic microphones put jumpers straight across all pins 
except for mic pins 5 and 6 ( no resistor for dynamic mics)
-- for other microphones, refer to the KSB2 instructions.
-- If you have a Heil microphone (not the Elecraft variety) it will have 
an adapter - wire the mic configuration header to correspond with the 
adapter used (Kenwood, Yaesu, or Icom).

73,
Don W3FPR

On 10/9/2014 5:11 PM, Matt VK2RQ wrote:
> If you don't get the mic adapter, and you use the Elecraft MH2 microphone, you can just jumper the standard headers directly across with the jumpers provided in the kit.