[Elecraft] BNC connectors for RG-8X Coax

[David Cole]

Hi,
Looking at the tech spec sheet I don't see a power rating?  Also
remember these are 75 ohm connectors...  Anyone know what the max power
you can pump through one of these are?

-- 
Thanks and 73's,
For equipment, and software setups and reviews see:
www.nk7z.net
for MixW support see;
http://groups.yahoo.com/neo/groups/mixw/info
for Dopplergram information see:
http://groups.yahoo.com/neo/groups/dopplergram/info
for MM-SSTV see:
http://groups.yahoo.com/neo/groups/MM-SSTV/info


On Thu, 2014-10-09 at 04:59 -0700, Dennis Griffin wrote:
> Sorry, here is a source for a connector similar to what I believe you are seeking, Phil, except that it's for LMR-200. The Tessco & TimesMicrowave sites also have good connector, and coax, info.
> 
> http://www.newark.com/amphenol-connex/112597/rf-coaxial-bnc-plug-str-50-ohm/dp/99H4490?ost=99H4490
> 
> 73 de Dennis KD7CAC
> Scottsdale, AZ
> 
> On Oct 9, 2014, at 4:17 AM, Dennis Griffin <EagleEyeDennis at gmx.com> wrote:
> 
> > I have ordered several jumper/adapter cables made with RG174 from WiFi RF Expert. They have been good quality. An example is a 24" RG174 BNC Male 90° to UHF Female for $12.29. He can custom make most anything an OM might want. RF Parts is a source for various RF connectors & inline adapters.
> > 
> > 73 de Dennis KD7CAC
> > Scottsdale, AZ
> > 
> > On Oct 9, 2014, at 3:38 AM, Joel Black <w4jbb at charter.net> wrote:
> > 
> >> Phil,
> >> 
> >> When I need one, I have been using the RF Industries RFB-1101-1P. These are solder-pin / clamp connectors. I don't remember from where they were purchased.
> >> 
> >> I don't remember what put me on these. I use them indoors only from my KX3 to an antenna switch and from the RX connector on my K3 to an antenna switch. I also have a 25' piece of RG-8x with a PL-259 on one end and the BNC on the other for when I go to the park and operate. I have not had any failures with them; your mileage may vary. :)
> >> 
> >> 73,
> >> Joel - W4JBB
> >> 
> >> On 10/9/14, 12:18 AM, Phil Hystad wrote:
> >>> I am looking to use BNC (male) connectors for RG-8X cable.  I have found a number of crimp style connectors but I am wondering if there are any other kind to consider.  Are the crimp style the best for reasonable cost?
> >>> 
> >>> My application does not need to be weather protective -- all use indoors.
> >>> 
> >>> Thanks,
> >>> 
> >>> 73, phil, K7PEH
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave at nk7z.net