[Elecraft] BNC connectors for RG-8X Coax

[Dennis Griffin]

Here is a source for the connector that I believe you are seeking.

http://www.newark.com/amphenol-connex/112597/rf-coaxial-bnc-plug-str-50-ohm/dp/99H4490?ost=99H4490

73 de Dennis KD7CAC
Scottsdale, AZ

On Oct 9, 2014, at 4:17 AM, Dennis Griffin <EagleEyeDennis at gmx.com> wrote:

> I have ordered several jumper/adapter cables made with RG174 from WiFi RF Expert. They have been good quality. An example is a 24" RG174 BNC Male 90° to UHF Female for $12.29. He can custom make most anything an OM might want. RF Parts is a source for various RF connectors & inline adapters.
> 
> 73 de Dennis KD7CAC
> Scottsdale, AZ
> 
> On Oct 9, 2014, at 3:38 AM, Joel Black <w4jbb at charter.net> wrote:
> 
>> Phil,
>> 
>> When I need one, I have been using the RF Industries RFB-1101-1P. These are solder-pin / clamp connectors. I don't remember from where they were purchased.
>> 
>> I don't remember what put me on these. I use them indoors only from my KX3 to an antenna switch and from the RX connector on my K3 to an antenna switch. I also have a 25' piece of RG-8x with a PL-259 on one end and the BNC on the other for when I go to the park and operate. I have not had any failures with them; your mileage may vary. :)
>> 
>> 73,
>> Joel - W4JBB
>> 
>> On 10/9/14, 12:18 AM, Phil Hystad wrote:
>>> I am looking to use BNC (male) connectors for RG-8X cable.  I have found a number of crimp style connectors but I am wondering if there are any other kind to consider.  Are the crimp style the best for reasonable cost?
>>> 
>>> My application does not need to be weather protective -- all use indoors.
>>> 
>>> Thanks,
>>> 
>>> 73, phil, K7PEH