[Elecraft] BNC connectors for RG-8X Coax

[Joel Black]

Phil,

When I need one, I have been using the RF Industries RFB-1101-1P. These 
are solder-pin / clamp connectors. I don't remember from where they were 
purchased.

I don't remember what put me on these. I use them indoors only from my 
KX3 to an antenna switch and from the RX connector on my K3 to an 
antenna switch. I also have a 25' piece of RG-8x with a PL-259 on one 
end and the BNC on the other for when I go to the park and operate. I 
have not had any failures with them; your mileage may vary. :)

73,
Joel - W4JBB

On 10/9/14, 12:18 AM, Phil Hystad wrote:
> I am looking to use BNC (male) connectors for RG-8X cable.  I have found a number of crimp style connectors but I am wondering if there are any other kind to consider.  Are the crimp style the best for reasonable cost?
>
> My application does not need to be weather protective -- all use indoors.
>
> Thanks,
>
> 73, phil, K7PEH
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to w4jbb at charter.net