[Elecraft] PX3 & Pigknob
Nick Garner
nwgarner at gmail.com
Fri Oct 3 12:45:05 EDT 2014
Hi Sid,
Thank you for confirming that it works. I think the second part is a
question for the Elecraft folks.
Elecraft,
If the KX3 is manipulated with the UP/DN commands via the serial port, is
that reflected to the PX3 in the same way that a VFO knob turn on the KX3
does?
73,
Nick
N3WG
On Fri, Oct 3, 2014 at 8:13 AM, Sid Leben <sid at leben.com> wrote:
> Hi Nick,
> Tnx for quick reply. Yes, when connect the Pigknob to the PX3 Acc1PC port,
> the knob works on the KX3 BFO, but the PX3 does not follow the knob
> rotation. The kx3 BFO changes, but the px3 does not.
> In this configuration, just the kx3 moves px3.
> Sid
>
> Sent from my iPhone
>
> On Oct 2, 2014, at 8:35 PM, Nick Garner <nwgarner at gmail.com> wrote:
>
> Hi Sid,
> You can daisy chain them, similar to the KXPA100. Connect the knob to the
> PX3 ACC1 PC port. Then the PX3 ACC1 XCVR port to the KX3 ACC1 port.
>
> 73,
> Nick
> N3WG
> On Oct 2, 2014 6:09 PM, "Sid Leben" <sid at leben.com> wrote:
>
>> Just finished the PX3 (kit) and it works like a charm. Now comes the
>> question.
>> I had a Pigknob attached to the “Acc 1” port. Now the Acc1 port is
>> connected between the KX3 & PX3.
>>
>> Can I “Y” the connection into the PX3, (From KX3 & Pigknob), or some
>> other way. If I had to chose, of course it’s the PX3 that wins…
>> Sid
>> KC2EE
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to nwgarner at gmail.com
>>
>
More information about the Elecraft
mailing list