[Elecraft] K-Line Full break-in

[k5oai]

Hold down the QSK side of the [BAND] button
watch the VFO B text
Holding down the QSK side again, toggles between FULL and SIMI break in.
the VFO B text will tell you when it switches, 
as well as the QSK text under VBO A's display when you are in FULL

from page 30 in the manual:


Hold QSK to select full break-in (QSK icon on) or
semi break-in operation. QSK allows others to
“break” your CW transmission by sending one or
two characters. With semi break-in selected (QSK
off), the K3 returns to receive mode after a time
delay you set using DELAY.
VOX must be turned on in CW mode to enable
both full and semi break-in operation. If PTT is
selected (VOX icon off), transmit must be activated
using PTT or by tapping XMIT . PTT is sometimes
activated using a foot switch.
For ultra-fast CW full break-in at up to 100
WPM, set CONFIG:CW QRQ to ON. If CW
QRQ is OFF, max speed using VOX is 60 WPM,
and PTT is required for 60 to 100 WPM.


73 & GB
K5OAI Sam





--
View this message in context: http://elecraft.365791.n2.nabble.com/K-Line-Full-break-in-tp7595245p7595258.html
Sent from the Elecraft mailing list archive at Nabble.com.