[Elecraft] K1

[Don Wilhelm]

Dave,

When the K1 detects a 2 band board, it will only show b1 and b2. You 
will have to set those two parameters each time you change the board.

The frequency offsets are remembered for each band, so unless there is a 
duplication of a band between the two boards, you will not have to 
change the offsets.

73,
Don W3FPR

On 11/17/2014 1:06 PM, w1dwz w1dwz wrote:
> Thanks to all who have helped me here on the Reflector  ,  maturing   as a
> ELECRAFT  "Newbie  "
>
> One more query.
> Using  ( 2 )    2 -channel filter  boards   , instead of the   4 channel
> board which is no longer available  , I am confused as to how to configure
> the channel  #'s  of them.
> It seems to me that each board should be set up  with   b1  and b2   on
> each board    and not     b1 ,  b2   on one board   ,  and   b3  , and
> b4   on the other  .    Is that a good assumption  ?
> the manual is a little sketchy  on this.
>
>