[Elecraft] K3 w/ Steppir

[Mike K2MK]

Hi Tex,

Almost. One leg of the Y cable is very short so you'll need a serial
extension cable. There's a good drawing from SteppIR that shows how the Y
cable connects to the multiple devices. Not specifically the K3 but any
transceiver. E-mail me directly if you need a copy. k2mk at comcast dot net

Change the K3 config setting:
CONFIG:AUTOINF to Auto 1

Of course you'll need the transceiver tracking option on the SteppIR
controller and on the SteppIR transceiver setup screen set:
MODE = KENW
Din should match your current K3 and PC baud rate.

The Y cable leg that normally goes to the transceiver will go to the P3
serial input and then the P3 serial output will go to the K3.

73,
Mike K2MK



pkhjr wrote
> Want my steppir to track my K3, is the Y cable from steppir all I need?  I
> have the KPA500, P3 and KAT500 if that makes any difference.  My log
> program is HRD.  Just got my steppir up last week......WOW.
> 
> Thanks
> 
> 73 Tex
> ka5y





--
View this message in context: http://elecraft.365791.n2.nabble.com/K3-w-Steppir-tp7594726p7594732.html
Sent from the Elecraft mailing list archive at Nabble.com.