[Elecraft] KX3 menu problem

[Wayne Burdick]

This could happen if the control cable from KX3 to amp were not properly connected. On power-up, the KX3 waits several seconds to see if the amp is responding, and if not, it sets PA MODE to OFF. 

Wayne
N6KR

----
http://www.elecraft.com

> On Nov 7, 2014, at 5:18 PM, George via Elecraft <elecraft at mailman.qth.net> wrote:
> 
> I am using KX3 with the KXPA100 Amp. Lately when I turn the KX3 off and  
> then back on the menu shows PA OFF and I have to reset it to on. Then I also  
> must turn the power setting back up to 100 watts. Any one else seen this  
> problem. I have the latest firmware installed.   73  George/W2BPI
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n6kr at elecraft.com