[Elecraft] [K2] MAB - anyone picking this up?

[Phil Wheeler]

Thanks, Ed. Sounds like good advice -- and I have that tool :-)

Phil W7OX

On 5/28/2014 11:59 AM, Edward R Cole wrote:
> I know not what a MAB board is, but I bought pcb's from ExpressPCB and 
> cut them using a dremel cutoff  wheel run against a metal ruler to 
> keep a straight line.  Comes out very neat.  The clue is to allow some 
> space on the board for cutting. For little projects this works out 
> cheaper.
>
> I made TR boards with RF sensing ckt as example and my five band LP 
> filter for the amplifiers I built.  Those were large boards (5.5x9 
> inch) so cutting was required.
>
> 73, Ed - KL7UW