[Elecraft] [K2] MAB - anyone picking this up?

[Dave KW4M]

The project is at that awkward point where more than a few prototypes are
desired but likely not enough to enable a reasonably priced production run. 
Ideally someone with resources beyond mine would want to pick it up at some
point if the numbers are there to justify it.

ExpressPCB's advice against cutting four layer boards was noted and
considered.  To reduce the possibility of shorts, the internal plane layers
were designed to have voids in the areas where cuts are to be made.  In my
estimation, electrical shorts due to cutting the boards is not an issue.




--
View this message in context: http://elecraft.365791.n2.nabble.com/K2-MAB-anyone-picking-this-up-tp7589489p7589611.html
Sent from the Elecraft mailing list archive at Nabble.com.