[Elecraft] K3 Noise Reduction Adjustment via CAT

[Tom]

Hi
Yes it is possible but not if you are not actually programming via rs232. 
You have to issue a SWR command (or Swh I'm working from memory here) Cohen read the vfoa display with a Ds command and then issue the appropriate up and down commands. Same for vfob. 
If you have no way to read the DS value and do some programming logic you are out of luck. 
Hope this helps
73s Tom 




-------- Original message --------
From: Charles Sanders <no5w.chuck at gmail.com> 
Date: 27/05/2014  22:29  (GMT-05:00) 
To: elecraft at mailman.qth.net 
Subject: [Elecraft] K3 Noise Reduction Adjustment via CAT 
 
Is it possible to adjust the K3 noise reduction level via CAT? I could not
find reference to it in the Programmer's Manual.

Any information on when/where that might be available would be appreciated.

73/Chuck/NO5W
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to tomb18 at videotron.ca