[Elecraft] Interfacing TS480 to KPA500

[Michael Walker]

All

My remote base runs on a TS480 and I will be adding a KPA500 to the mix.

In going over the documentation, I find that there is very little detail on
actually interfacing on the RS232 port.  From what little I can read, I see
it is as simple as plug it in and go, or am I missing something in the
configuration.

Can I pass RS232 signal through the Amp or is it a passive listener and
handles band changes.

I will also be using a KRC2 to change filters and antennas in the same
solution.

Mike va3mw