[Elecraft] N1MM and keying KX3. What happens to the slashes //

[Don Wilhelm]

Joe,

Since the call is both sent and logged without the "/", I would believe 
it is some condition in N1MM causing that behavior, and has nothing to 
do with the KX3.
Check the N1MM documentation (or ask on the N1MM forum) to see if the 
"/" character is used as an "escape" character.  If it is, then entering 
two of them would be necessary to actually send and log the '/'.

73,
Don W3FPR

On 5/21/2014 3:05 PM, Hans J Rasmusen OZ7BQ wrote:
> Group,
>
> Have been using the KXUSB cable to key my KX3 from the N1MM logger with the KY commands. That setup works fine, however during a recent trip as OZ7BQ/P, I discovered, that my call was send as OZ7BQP. Same thing happens when I logged a station like W1AW/0, it was logged as W1AW0.
> The problem can be solved by typing 2 slashes e.g. OZ7BQ//P, but the final log must then be filtered before use and uploading. But what is the significance of the slash? and is there as way around the problem?
> 73 de OZ7BQ, Hans Joergen (Joe).
>