[Elecraft] Reading 'extended' data from menus via serial

[David Patino]

I'll answer my own question.

Once that menu setting is active, DS; command will return what the 
display is showing.

-Dave


On 5/20/2014 3:53 PM, David Patino wrote:
> Howdy,
>
> So some of the menu options have a basic setting, ie on/off, but then 
> an extended setting as well. For example the Alarm menu:
> MN000;
> When read with MP; it will only report if the alarm is on or not (Bit 
> 4 on / off)
> you can turn it on or off by changing that bit with MP, and you can 
> change the hours/minutes setting (after sending the right SWT command) 
> using UP; or DN;, but is there any way to read what time the alarm is 
> set to?
>
> The programming reference says "(In some cases, more than one value 
> can be accessed for a given menu entry via the numeric keys;
> see menu listing in manual.)"
>
> All the manual says for the alarm menu is:
> Num 1 turns the alarm on/off
> Num 2 select hours
> Num 3 selects minutes
>
> None of these change what is reported by MP though and I can't seem to 
> find anything else in the manual.
> Anyone know if it's possible to read that value? TX ESSB is another 
> one. MP turns it on/off, but not sure how to read the bandwidth setting.
>
> 73 N9PBJ
> -Dave
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave at onitap.com