[Elecraft] Need Audio for SignaLink from Sub-Rx on my K3

[Joel Black]

Bob,

In regards to RX audio only: if the 0404 has a *stereo* input, it will 
listen to the MainRX on the left channel and the SubRX on the right 
channel when the SubRX is activated. *If* what you're looking for is 
being able to receive the audio from the SubRX, you will have to have a 
stereo sound card. If the 0404 does that, you should be good.

If you're talking about anything else regarding the XV50, I'm not sure I 
understand that part as I don't use one.

73,
Joel - W4JBB


On 5/14/14, 7:06 AM, Bob KD7YZ wrote:
> On 5/14/2014 06:09, Joel Black wrote:
>> Unless I am misunderstanding the question, you cannot. Not with a
>> SignaLink. The SignaLink is a mono input sound card (unless you re-wire
>> the plug to listen to the SubRX).
>   I do have an EMU-0404 though. I haven't used it in two years and it's
> in a drawer. How would this help me? Are you saying it can split the
> Sub-Rx audio out of the the two? ..Currently we take the SignaLink audio
> out the rear line in Line out places.
>
> I do realize the Sub-Rx audio is split when listening thru the headsets.
>
>
> I am using the Sub-Rx because I see no other way to use a separate
> receive line when I am using the internal 6m band. I have an Elecraft 6m
> XV50 but am needing to split the Rx input on it and haven't gotten
> around to it. It is wired to be able to take in Rx coax and have the Tx
> o the other conn. ... O want Split lines to simplify using high-end
> preamp w/o the usual possibility to kill said pre-amp if I screw up
> timing. I am not going to debate the use of this method as I used it
> extensively in the past in the 70's to 90's .
>
> So, the gal is to find the near term solution for using internal audio
> form the Sub-Rx.
>
> I will re-install the EMU0404 and see how to get the audio out.
>
> thanks for the idea.
>
>