[Elecraft] Power problem

[Bill Turner]

ORIGINAL MESSAGE:          (may be snipped)

On 5/13/2014 12:19 AM, Clive Lorton wrote:
> Bill,
> I had this problem while building my K3 recently.
>
> I spoke with the factory as it was fine when first tested.
>
> It turned out that I had not tightened all the screws down when 
> refitting the PA. Once tightened down it came back to life. During my 
> conversation I was also told to check that the screws on the 
> regulators (bottom panel) are tight enough.
>
> 73 Clive G8POC 

REPLY:

Thanks Clive, will do.

73, Bill W6WRT
dezrat at outlook.com