[Elecraft] Making a Signalink cable for the K3's 8-pin mic

[Slava Baytalskiy]

I just had a thought: what about the rear mic jack (the 3.5mm) and the line out?
Can that be done?

__________________
Slava (Sal) B, W2RMS
W2RMS at arrl.net

On May 10, 2014, at 1:29 PM, Bruce Beford <beford at myfairpoint.net> wrote:

> With all due respect, you already received the answer here. Yes, you can
> connect the Signal Link to the front panel mic connector. Just pad the audio
> output of the SL to a mic level, instead of line level. Also, you won't be
> able to get audio output from the K3 back to the SignalLink via that jack.
> The RX audio of the K3 is not available there (see the manual). So you would
> need another cable from line out on the back for that anyway.
> 
> So... it would be easist to just patch it in via the back (via your rack of
> signal shaping/mixing gear), as has been suggested.
> Bruce
> N1RX
> 
> 
>> I knew this was going to turn into "why do you need all that audio gear" 
>> discussion.
> 
>> Never mind. Thanks for your input.
>> I guess i'll just ask Eric or Wayne next Friday at Dayton.
> 
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to slavka at nullserv.com