[Elecraft] KPA500 - LED Alignment

[Harry Yingst]

Thank you 

I have still to order the Amp, it was just something I was curious on.





________________________________
 From: Tighe Kuykendall <tk at nk4i.com>
To: elecraft at mailman.qth.net 
Sent: Friday, May 9, 2014 2:49 PM
Subject: Re: [Elecraft] KPA500 - LED Alignment
 

I believe the manual says to use a straight edge or ruler to gently push 
against them to align the LEDs.  That's what I did and mine are all 
fairly well aligned.

Tighe
NK4I


On 5/9/2014 2:34 PM, Harry Yingst wrote:

> ________________________________
>   From: Don Wilhelm <w3fpr at embarqmail.com>
> To: Harry_Yingst <hlyingst at yahoo.com>; elecraft at mailman.qth.net
> Sent: Friday, May 9, 2014 2:29 PM
> Subject: Re: [Elecraft] KPA500 - LED Alignment
>
>
> Harry,
>
> Remove the front panel enclosure and tilt the LEDs until they are
> aligned to your satisfaction, then put the front panel metalwork back
> on.  They will stay aligned.
>
> 73,
> Don W3FPR
>


>


-- 
Tighe Kuykendall
NK4I  |  www.NK4I.com  |  Follow Me on Twitter: @NK4I
ARRL Life Member, NAQCC #6467
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to hlyingst at yahoo.com