[Elecraft] K3-100 low power output

[Harry Yingst]

Are you doing the TX Calibration with a dummy load?







________________________________
 From: Greg Leber <greg7412 at gmail.com>
To: Elecraft <elecraft at mailman.qth.net> 
Sent: Thursday, May 8, 2014 4:48 PM
Subject: [Elecraft] K3-100 low power output
 

Today when I tried to drive my AL1200 amp I found the K3 was not putting
out enough power. It drives the KPA500 fine but that only requires about
20W. I hooked it to a dummy load and this is what I found.
10m 66w
12m 103w
15m 80w
17m 88w
20m 94w
30m 106w
40m95w
80m 87w
160m 91w
I did the Xmit gain calibration using the utility and I have no error
messages. The finals must be OK because I have over 100w on two of the
bands. Do anyone have any Idea what's going on here?

Greg (K9ON)
-- 

"Life is hard; is's harder if you're stupid."

John Wayne
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to hlyingst at yahoo.com