[Elecraft] K3-100 low power output

[Pfizenmayer]

If you have the K3 internal tuner did you have it in bypass when you did the 
tx gain cal routine  ????

Looks like a possibility is the K3 put in some pre determined saved networks 
by band. ???


Hank K7HP
----- Original Message ----- 
From: "Phil Wheeler" <w7ox at socal.rr.com>
To: <elecraft at mailman.qth.net>
Sent: Thursday, May 08, 2014 2:12 PM
Subject: Re: [Elecraft] K3-100 low power output


> Assuming the list below is the K3 barefoot into a dummy load (and not the 
> AL1200 driven by the K3), how much drive does the AL1200 specify?
>
> Phil w7ox
>
> On 5/8/14, 1:48 PM, Greg Leber wrote:
>> Today when I tried to drive my AL1200 amp I found the K3 was not putting
>> out enough power. It drives the KPA500 fine but that only requires about
>> 20W. I hooked it to a dummy load and this is what I found.
>> 10m 66w
>> 12m 103w
>> 15m 80w
>> 17m 88w
>> 20m 94w
>> 30m 106w
>> 40m95w
>> 80m 87w
>> 160m 91w
>> I did the Xmit gain calibration using the utility and I have no error
>> messages. The finals must be OK because I have over 100w on two of the
>> bands. Do anyone have any Idea what's going on here?
>>
>>   Greg (K9ON)
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to pfizenmayer at q.com