[Elecraft] KX3 Macro programming question?

[Peter Eijlander (PA0PJE)]

Hi Glenn,

I did something else for that purpose; I created a small pigs tail with 
a two pin female connector and a 6.3 mm female stereo connector at the 
other end for my straight key and plug the paddle in the "key" connector 
at the left side. In the setup I set the side connector to normal iambic 
and the front connector to "HAND" so I can use both without any 
switching at all.

The rightmost 2 vertically oriented pins in the hole that is used to 
connect the portable paddle, are to be used in that case. The small 
connector was salvaged from some junk-box-PCB and sealed with shrink-tube.

If you like I can send you a picture of what I made.

73,
Peter


Op 2014-05-05 22:25 schreef WA7SPY:
> " <elecraft at mailman.qth.net>

> I would like to use my PF1 and PF2 buttons on my KX3 to do the following:
> PF1 change CW Key 1 from tip dot to HAND
> PF2 change CW Key 1 from HAND back to tip dot.
>
> I have tried the KX3 utility with the test commands. I can give the command:=
>
> MN,120; MP128;  (KX3 goes to CW Key 1 tip dot)
>
> MN120; MP127; (KX3 goes to CW Key 1 HAND
>
> When I write these commands to Macro 1 and 2 respectively both PF1 and PF2 p=
> ut the KX3 to CW Key 1 HAND. How do I set this up so I can toggle between CW=
>   Key1 tip dot and CW Key 1 HAND using PF1 and PF2?=20
>
> I like to switch between my bug and single lever paddle and using PF1 and PF2=
>   would be nice to use to toggle the tip from dot to HAND and back.
>
> Thanks in advance,
> Glenn WA7SPY
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to pa0pje at xs4all.nl
>