[Elecraft] K1 test problem

[Mike Morrow]

> I am a first time "K1" builder and am having a very difficult
> time getting the proper voltage measurements for the test on
> page 46 of the manual.  
> Test point J7 pin 8 should be 3.8vdc  I get "0"
> The test points on Diodes "D9","D10","D11","D13", all measure "0"

Are you sure you performed this step correctly, just before taking the
voltage readings:

"Place the transmitter in TUNE mode (key-down), by holding
the W P M + and W P M - switches simultaneously."

Mike / KK5F