[Elecraft] K3 Kit Wisdom

[Harry Yingst via Elecraft]

I had to remove that standoff to get the shield out (and back in)
so I could cut a notch in the shield for the two meter antenna cable




________________________________
 From: Gary W. Hvizdak <gary.hvizdak at cfl.rr.com>
To: elecraft at mailman.qth.net; kk4oyj at gmail.com 
Sent: Saturday, May 3, 2014 8:04 PM
Subject: Re: [Elecraft] K3 Kit Wisdom
 

Sat May 3 19:24:08 EDT 2014 

Hank K7HP writes ...

John -  One  other small step for K3 assemblers  that  I felt should be done
earlier is on page 58 of the K3 assembly manual  "KNB3 installation
procedure"

My note to myself was the standoff for the noise blanker should be done
BEFORE the KPA3 shield step or even earlier - it was a dog for me to get
that standoff mounted after the KPA3 shield was in place.

--- - - - ---

I thought so at first as well but after studying the situation, realized
that it had to be done in the order specified.  (I don't recall why.)

73,
Gary  KI4GGX
K3 #2724


______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to hlyingst at yahoo.com