[Elecraft] [K2] Receiver overload protection

[Matt VK2RQ]

Thanks Don. I was chatting to a fellow KX3 owner about how the KX3 protects itself in the presence of strong RF, and he remarked that my K2 would probably do the same. When I looked into it, I was reaching similar conclusions as you, although I didn't find any information about maximum signal ratings for the mixer.

BTW, 39mW corresponds to 16dBm, which is indeed huge. I calculated 0.14Vrms to be more like -4dBm (ie. an S9+69dB signal), but maybe there's a stray decimal point, or I've missed an assumption somewhere.

Anyway, best thing is to take some measurements, and see if an external protection device is warranted. Thanks to Steve for the diode suggestion when using separate receive antenna.

73,
Matt VK2RQ

> On 3 May 2014, at 5:06 am, Don Wilhelm <w3fpr at embarqmail.com> wrote:
> 
> Matt,
> 
> There is no provision for that as far as I know, however the 2N5109 used in the K2 preamp stage is quite a robust transistor.  For instance the absolute maximum base to emitter voltage is rated at 3 volts and the K2 preamp design raises the emitter 1.3 volts above the board ground.  It would take a very healthy signal on the K2 input to produce greater than 3 volts peak at the base to emitter junction.
> Even the K2 Receive Signal Tracing instructs one to inject a 0.14 volt RMS signal for tracing purposes, and that is a very strong signal (I calculate 39 mW).
> 
> The 1st mixer (a TOP1 diode ring mixer) is capable of handling very large signals as well.
> 
> I would not drive a 5 watt signal directly into the K2 receiver and expect no damage, but under normal operation there should be no problem.
> If you are expecting an extremely large signal on the feedline while the K2 is connected, I would suggest that some external protective device be added to your station.
> 
> 73,
> Don W3FPR
> 
>> On 5/2/2014 2:32 PM, Matt VK2RQ wrote:
>> When building the K2, one installs a couple of back-to-back diodes across the input of the IF amplifier to clamp the input voltage. However, if there is a large signal on the antenna during receive, what protection is there for the RF preamp transistor and the first mixer? Does the micro controller monitor the V_RFDET line on the antenna during receive, and switch out the preamp/switch in the attenuator when a large signal is detected?
>