[Elecraft] Firing off a macro via MixW

[David Cole]

Again, thank you Tony!!!  Now that I am finally getting moved into the
K3, it is time to start addressing the lost macros from my Pro 3.  I had
not used the CATCMD from MixW, so that will be a fun!!!  Sure will make
it easy!

I just wish FLDigi did direct RTS or DTR keying for CW now, I'd consider
moving to it from MixW.  I detest the audio only interface FLDigi uses
for CW keying.

-- 
Thanks and 73's,
For equipment, and software setups and reviews see:
www.nk7z.net
for MixW support see;
http://groups.yahoo.com/neo/groups/mixw/info
for Dopplergram information see:
http://groups.yahoo.com/neo/groups/dopplergram/info
for MM-SSTV see:
http://groups.yahoo.com/neo/groups/MM-SSTV/info


On Fri, 2014-05-02 at 10:55 -0500, Tony Estep wrote:
> On Fri, May 2, 2014 at 10:22 AM, David Cole <dave at nk7z.net> wrote:
> 
> > ...Where did you get the list of commands...
> 
> ===========
> If you have the MixW help files installed, you can find a very extensive
> list of macro commands there. The best way to send commands to the K3 is
> not via Hex, but via CATCMD. Then you just follow the Elecraft Programmer's
> Guide. Here's an example:
> 
> <CATCMD:KY <MYCALL>;>
> 
> You start with <CATCMD:  Then you append the instructions as found in the
> Programmer's Guide (downloadable from the Elecraft software page). There
> are many examples there already worked out for you, so you can just copy
> them or modify them to your needs.
> 
> Tony KT0NY
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dave at nk7z.net