[Elecraft] K3 1 mW tx calibration fails

[Pierfrancesco Caci]

Solved. For those checking the archives, it was an outdated k3util,
upgraded that and all went good.

Pf

>>>>> "Pierfrancesco" == Pierfrancesco Caci <pf at tippete.net> writes:


    Pierfrancesco> Hello,
    Pierfrancesco> I'm trying the 1 mW tx calibration and it fails like this:

    Pierfrancesco> Elecraft K3 Utility for Linux Revision 1.13.4.15
    Pierfrancesco> K3 MCU revision 04.81. RS-232 speed 38400 bps.
    Pierfrancesco> Starting 1 milliwatt calibration.
    Pierfrancesco> Calibrating at 1.900 MHz
    Pierfrancesco> Calibrating at 3.750 MHz
    Pierfrancesco> IsSamplingComplete: Unexpected response 'DB 2.08 MW;' to ''.
    Pierfrancesco> Calibration power settled at ' 2.08 MW;'
    Pierfrancesco> 1 milliwatt calibration failed.
    Pierfrancesco> Elapsed time: 25.2 secs

    Pierfrancesco> Any clues?

    Pierfrancesco> The dummy load I've connected is flat at 51 Ohm all throughout the
    Pierfrancesco> range (tested with miniVNA).

    Pierfrancesco> Pf

    Pierfrancesco> -- 
    Pierfrancesco> Pierfrancesco Caci, ik5pvx
    Pierfrancesco> ______________________________________________________________
    Pierfrancesco> Elecraft mailing list
    Pierfrancesco> Home: http://mailman.qth.net/mailman/listinfo/elecraft
    Pierfrancesco> Help: http://mailman.qth.net/mmfaq.htm
    Pierfrancesco> Post: mailto:Elecraft at mailman.qth.net

    Pierfrancesco> This list hosted by: http://www.qsl.net
    Pierfrancesco> Please help support this email list: http://www.qsl.net/donate.html
    Pierfrancesco> Message delivered to pf at tippete.net

-- 
Pierfrancesco Caci, ik5pvx