[Elecraft] KRX3 K3 Subreceiver Install

[Vic Rosenthal K2VCO]

It's not hard, but be careful plugging in the small coax cables. If they 
seem to require a lot of force, you may not have aligned the center pin 
with the contact in the jack on the KRX3 board. Too much force can 
damage the jack or the board.

On 3/27/2014 5:23 PM, Charles Tropp wrote:
> Hi Phil,
>
> I installed my sub-receiver a few months ago without difficulty. If you
> have been inside your K3 previously, all will seem familiar. If not,
> just follow the directions precisely and you will have no trouble. Don't
> forget to install all your filters for the main receiver before you
> start the new installation so that you don't have to take everything
> apart again to reach them. By the way, I just love KRX3. It is so easy
> to work split now that I cannot remember how I did it before.
>
> Good luck,
>
> Charles, N2SO
> On 3/27/2014 7:32 PM, Oliver Dröse wrote:


-- 
73,

Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/