[Elecraft] [k3] Mic Gain: Option 7

Sam Morgan k5oai.sam at gmail.com
Thu Mar 13 09:08:30 EDT 2014


Page 20 K3 Owner's man D10.pdf

MIC
MONO; hi- or low-Z
This jack accommodates an electret or dynamic
mic. Use MAIN:MIC SEL to select the rear panel
mic (RP). Tap 1 to turn on Low or High mic gain
range. Tap 2 to turn bias on/off (see pg. 28 for
recommendations based on mic type).
For the front-panel mic only, additional microphone
gain can be enabled by tapping 3 . Use this only for
very low-output mics.

page 52 K3 Owner's man D10.pdf
MIC SEL
Mic/line transmit audio source, mic gain range, and mic bias. Source 
selections:
FP (front panel 8-pin MIC jack), RP (rear panel 3.5 mm MIC jack), and 
LINE IN
(rear-panel LINE IN jack). Tap 1 to toggle between .Low and .High mic 
gain range
for the selected mic. Tap 2 to turn mic BIAS on/off (turn on for 
electret mics).
For the front-panel mic only, tap 3 to turn on an additional gain stage. 
Use this only
with very low-output mics. An apostrophe will appear after the H, e.g. H’ .



only place I find tap 7 in the manual is under FLx BW on pg 55
also mentioned on pg 24


however when in the MIC SEL menu for the front panel mic
taping 3 gives a N/A result

taping 7 *WILL* give the desired mic boost for the front panel mic

taping 3 or 7 gives a N/A when rear mic is selected

I just checked in the ERRATA for the K3 Owners manual and it's not there 
either

looks like there needs to be an editing job in the manual ;-)

On 3/13/2014 7:40 AM, bill conkling wrote:
> And tap 7 for an additional 10db of gain!
>
> I'm sure " Its in the book!"
>
> ...bill nr4c
>
> /Sent from my Verizon Wireless 4G LTE DROID/
>
>
> Sam Morgan <k5oai.sam at gmail.com> wrote:
>
> tap MENU to get into MAIN
> locate MIC SEL
> tap DISP
> read the info that scrolls across VFO B
> it will tell you about toggling Boost <Hi/Lo>
> by taping Number 1 on the number pad
>
> On 3/12/2014 8:40 PM, John wrote:
>  > I'm trying to setup a set a Radio Sport headset, with the M350 Electret
>  > microphone. The mic is connected to the K3 rear panel mic jack. The
>  > Arlan instructions recommend using "Option 7" for +10 DB of additional
>  > Mic Pre-amp gain for close-talk mics.
>  >
>  > How do you set "Option 7"? What menu is it in?
>  >
>  > Thanks,
>  >    - 73, John, N0TA
>

-- 
GB & 73
K5OAI
Sam Morgan


More information about the Elecraft mailing list