[Elecraft] K3 digital mode

[Matt Zilmer]

Hi Mike,

If you're using external sound for your data modes, you should have
the mode set to DATA A, not AFSK A.  Having your audio  set to Line in
DATA A mode is correct, unless you're going through the mic and phones
jacks.  Most people use the line in/out for external data modes (very
handy!).

For keying, see CONFIG:PTT-KEYT.  You can use DTR or RTS to key the
K3.  You can also enable VOX, but there will be a slight start up
delay before the rig enters TX (probably not enough to worry about).

73,
matt W6NIA

On Tue, 4 Mar 2014 08:32:27 -0500, you wrote:

>I started to play with RTTY this morning, and cannot get the K3 to transmit.
>
>The K3 is set for AFSK A, 2125 170. Vox is on. Monitor level is 15. CW works FB.
>
>The computer is a MacBook Pro pushing an iMic set for line level. I can hear the output from the iMic if I plug fones into it.
>
>The RTTY program is CocoaModem 2.0.
>
>What have I missed/mis set?
>
>73, Mike NF4L
>
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
Matt Zilmer, W6NIA
--
"Give me six hours to chop down a tree and I will
spend the first four sharpening the axe." -A. Lincoln