[Elecraft] K3 - rig control with a Pigknob

[Vic, K2VCO]

A couple of things I've wondered about:

1) Can you load firmware while the device is connected?
2) Are there any issues if a P3 is daisy-chained?

I looked at the Pigknob user manual and the answers weren't obvious.

On 6/28/14 6:50 AM, Bill W2BLC wrote:
> For a long time I have been using HRD to allow rig control of my K3 -
> using the mouse and computer for control of various features/controls
> and the VFO. Then I discovered the Pigknob - http://pignology.net/pigknob/
>
> The Pigknob allows me to control 8 programmable features and the VFO (at
> two selectable speeds). I merely used the K3's Programmers Reference to
> help set up the eight buttons. If you can operate a feature or control
> from the front panel of the K3 - you can do it from the Pigknob.
>
> Now I am able to easily control and use the K3 from my arm-chair
> (remember, all I do is arm-chair copy rag chew) without having to
> stretch across the desk to reach the K3's panel. The wire from the
> Pigknob to the K3 is plenty long enough for placement of the device
> anyplace on the desk, or to hold in my hand.
>
> I am glad I found the Pigknob, as it ended my quest for a remote control
> pad. Also, it does not require the use of a computer, except when
> programming it. It is stand alone with the K3.
>
> I have no financial interest in the company that sells the Pigknob - I
> am merely pointing out a device that works well for me and may do so for
> others.
>
> As a parting comment: The Pigknob is the best station add-on I have
> bought in many years. It does its job very well.
>
> Bill W2BLC K-Line

-- 
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/