[Elecraft] N1MM and K1EL Winkey

[Don Wilhelm]

Kevin,

If you have moved the USB connection from connector to connector, check 
your USB port assignment in Control Panel.  Sometimes a different com 
port is assigned to USB to serial adapters unless the same USB port is used.

73,
Don W3FPR

On 6/27/2014 7:46 PM, Kevin wrote:
> Thus far I have found a few of the problems.  I needed an FT232R 
> driver.  Now the Winkey can drive the K3 just fine.  N1MM on the other 
> hand cannot seem to run the K3 at all.  While the USB connection is on 
> COM 4 the serial port between the keyer and the laptop does not work 
> on COM 1.  I am not sure what changed since I last had this all 
> working.  Any suggestions for getting N1MM to drive my K3?  I may need 
> to reboot a few more times; this is a windows machine after all :)